This store requires javascript to be enabled for some features to work correctly.
Our leg wraps are made from architectural film, so are strong and durable, but also incredibly easy to apply. Watch our short install video below to get a flawless, long-lasting result.
Clean and dry your highchair legs
Peel backing about 10cm
Start with the two front legs and locate the push button.
Before you start, locate the push button. You'll want to wrap the adhesive so the seam joins on the opposite side of the push button. That way, the seam will be out of your line of vision.
Apply from bottom to top
Work from bottom to top, starting where the white foot and the highchair leg meet.
Press the adhesive down
Press the adhesive down as you slowly peel the paper back.
Wrap the adhesive one side at a time
Wrap the adhesive around the leg one side at a time, gently smoothing out any bubbles or ridges as you go.
Apply some heat to strengthen the seal
Apply some heat along the seam (can use a hairdryer) to activate the adhesive and strengthen the seal.
Repeat the same steps for the back legs
For the back legs, wrap the adhesive so the seam joins on the opposite side of the push button. That way, the seam will be out of your line of vision. Repeat all other steps.
Trim any overlaps
Trim any overlaps with a box cutter or small knife and remove the excess.